|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 26th 05, 07:56 PM
|
|||
|
|||
Correct clipper blade for undercoat
I have been shaving my dog for several years and have an Oster A5
clipper. I have the default blade that came with it (#10), but this cannot go through the thick undercoat around her haunches, so I have to cut this by hand with a pair of shears (very frustrating). I was wondering what kind of blade I could get to go through her thick undercoat? Should I use a skip-tooth blade? Thanks for any advice you can give me. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Andis clippers..... is anyone familiar with them? | esrade | Dogs - general | 3 | November 26th 03 07:09 PM |
| Clipper Burn? Groomers Please? | Judy | Dog behavior | 16 | November 22nd 03 12:57 PM |
| Clipper Burn? Groomers Please? | Judy | Dog behavior | 0 | November 21st 03 02:24 AM |
| Clipper Burn? Groomers Please? | Judy | Dog behavior | 0 | November 21st 03 02:24 AM |
| Clipper Burn? Groomers Please? | Judy | Dog behavior | 0 | November 21st 03 02:24 AM |
Linear Mode
